There are three types of car positioning equipment: wiring type, OBD interface type, and strong magnetic (free installation type). According to these different types, the detection methods are as follows.

1, directly search for the car (strong magnetic free installation type)

In order to avoid the car GPS locator being found, people will try their best to install the GPS locator in some hidden places, such as near the front and rear bumpers, inside and outside the door. Therefore, in order to find a GPS locator that has been maliciously installed, we can first look for it from the following locations and locations in the figure.

2, follow the vine, check the line (wiring type)

At present, most of the GPS locators on the market are wired type, and need to connect the car power cord to provide power. Therefore, in order to find the car GPS locator installed by people, it is also a good way to search along the power line of the car. . However, this method is more difficult for people who are not familiar with the car. It is recommended that the owner should go to the car repair station to check the line, otherwise the car line may be damaged.

3. Check the OBD interface (OBD interface type)

Nowadays, many OBD devices have functions such as positioning and driving detection, as well as positioning and driving records. This type of device can be used on the OBD interface, so check the OBD interface when looking for it. The position of the OBD interface is as follows: A, located in the lower left corner of the steering wheel (most common); B, located in the lower right corner of the steering wheel; C, near the igniter below the center console; D, in the central armrest box.

4, GPS model detector (general)

The GPS locator needs to install a SIM card to receive and send information, so the car GPS locator has a certain frequency and can be monitored by a GPS signal detector. The owner goes to the electronics market to buy a device that traces the signal of the mobile phone. Take this item and search around your car, and you will soon find the location of the installation. For signal detection, you can start the car, then use the mobile radio, turn on the radio, find a channel with the clearest voice, move around the car, and if the radio moves to somewhere there is an abnormal sound, indicating that you found it.

5, GPS shield shielding signal (universal)

If the above method is still not found, teach you the simplest and most rude method. Search the GPS goggles (or jammers) online, install them in the car after purchase, and shield any signals in the car, so you don't have to worry about the car being tracked. However, the shield will shield the phone's signal interference, which is not desirable.